With the projector remote, press and hold the 'On' button for 5 seconds while pointing the remote at the projector. Once you hear or see the projector coming on you can release the on button.
Q2 - How do I view the computer on the projector?
Power on the projector. Power on the computer. On top of the computer is a 2-way switch box. Make sure the switch is set to position 'A' for the computer. If you do not see anything on the screen then press the button labeled 'Video' on the projector remote until you can see an image.
Q3 - How do I view the document camera on the projector?
Power on the projector. Power on the document camera. On top of the computer is a 2-way switch box. Make sure the switch is set to position 'B' for the document camera. (Note, the label may read 'Samsung Digital Presenter'.) If you do not see anything on the screen then press the button labeled 'Video' on the projector remote until you can see an image. Click here for further instructions on document camera usage.
Q4 - How do I view the DVD player on the projector?
Power on the projector. Power on the DVD player. With the projector remote, press the 'RGB' button until the DVD player is viewable on the screen. Use the DVD remote to control DVD playback operation.
Q5 - How do I view the VCR player on the projector.
Power on the projector. Power on the VCR player. With the projector remote, press the 'RGB' button until the VCR player is viewable on the screen. Use the VCR remote to control VCR playback operation.
Q6 - How do I use my laptop with the teaching station?
Follow the steps below.
Power on the projector.
Follow Q3 instructions for powering on the document camera. (Make sure you can view the document camera before proceeding!)
There is a supplied cabled attached to the rear of the document camera. Connect this cable to the rear of your laptop and boot your laptop.
On the document camera there is a button labeled 'INT/EXT'. Press this until the light next to EXT1 is lit.
You should now be able to view your laptop. If you still cannot view your laptop then you need to change your output on the laptop. On the laptop simultaneously press the 'Fn' key (ususally blue and in lower left hand corner of keyboard) and the 'F8' key. ('Fn' and 'F7' for IBM laptops.) Continuously do this until you can view your laptop display on the screen. If needed, click here for further instructions on laptop usage.
University Teaching & Learning Center The University of North Carolina at Greensboro
134 McIver Building
Greensboro, NC 27402-6170 VOICE 336.334.5078 FAX 336.334.3014 EMAILutlc@uncg.edu
