Online Services
Events
Resources
- Teaching Station Instructions
- For Classroom Technical Support Call 334-5207
- Collaboratory Reservation System
- Collaboratory Instructions
- TLC Room Reservations
University
Teaching & Learning Center
Teaching Station Instructions - Humanities Building (MHRA)
This page is only for rooms 1304, 3207, and 3209 in the MHRA building. These rooms have special setups. All other rooms in MHRA use the control pad interface. If you are needing these instructions please refer to the previous page.
These three rooms include a portable kiosk with a DVD/VCR player. There is no teaching station. They are intended primarily for viewing video or using a laptop. Because there is no teaching station all connections are mounted on a wall plate at the front of the room. The projector remote controls the inputs, laptop or DVD/VCR.
 |
 |
|---|
Frequently Asked Questions
-
Q1 - How do I turn on the projector?
- With the projector remote, press and hold the on button for 5 seconds while pointing the remote at the projector. Once you hear or see the projector coming on you can release the on button.
- Q2 - How do I view the DVD/VCR player on the projector?
- Power on the projector. Power on the DVD/VCR player. In the kiosk, there is cable with three ends coming out of the rear of the DVD/VCR player. Connect this cable to wall connectors. Be sure to match the colors on the cable to the same colors on the wall. If you do not see anything on the screen then press the button labeled 'RGB' on the projector remote until you can see an image.
- Q3 - How do I view my laptop on the projector?
- Follow the steps below.
- Power on the projector.
- Connect the supplied cable to your laptop and boot your laptop.
- If you do not see an image there could be two problems. Either the projector isn't set for the correct input or your laptop isn't set for the correct output. With the projector remote, press the button labeled 'Video' continously until you can see an image. If this does not work then you most likely need to set the output on your laptop. On your laptop, press the 'Fn' key (ususally blue and in lower left hand corner of keyboard) and the 'F8' key. Continuously do this until you can view your laptop display on the screen. If needed, click here for further instructions on laptop usage.
- Follow the steps below.